reg {
  xsize1   = 25.0  
  xsize2   = 25.0 
  ysize    = 28.0
  xover    = 2.0
  angle    = 0 
  mirror   = no
  xoff     = 1.0
  yoff     = 1.0
  version  = 1
  xorigin  = 1.0
  yorigin  = 1.0
  dx1      = 0
  dx2      = 0
  dy1      = 0
  dy2      = 0
  xscale   = 1.0
  yscale   = 1.0
  xscale_o = 0.0
  yscale_o = 0.0
}

format {
  format        = excellon2
  zeroes        = trailing
  units         = mm
  tool_units    = mm
  nf1           = 3
  nf2           = 3
  decimal       = no
  modal_coords  = no
  incremental   = no
  repetitions   = sr
  single_sr     = no
  sr_start_code = 25
  sr_zero_set   = no
}

optimize {
  optimize          = yes
  break_sr          = yes
  xspeed            = 100
  yspeed            = 100
  iterations        = 5
  reduction_percent = 1
  diag_mode         = 45ort
}

rout_layer    = drl2rt
hook_units    = inch
no_touch_cpr  = yes
tent_ar       = 0


nibble {
  custom = no
  val {
    min_size = 0
    max_size = 200
    num_holes = 50
  }
  val {
    min_size = 200
    max_size = 999
    num_holes = 100
  }
}

slot {
  custom        = no
  overlap       = 8.0
  total_overlap = 10.0
}

z_axis {
  z_head   = 10
  zone {
    x_min  = 0
    y_min  = 0
    x_max  = 0
    y_max  = 0
    z_head = 10
  }
  zone {
    x_min  = 0
    y_min  = 0
    x_max  = 0
    y_max  = 0
    z_head = 10
  }
}

time {
  bit_change  = 1.0
  tool_change = 1.0
}

tools_assign {
    mode          = increasing_size
    use_hole_tol  = no
    choice_method = default_fit
    #tool_entry {
	#	tool = 1
    #    size = 126.181
    #}
}

start_end {
   split {
      start    = no
      end      = no
      min_dist = 20
      x1       = 2.0
      y1       = 0.2
      x2       = 3.5
      y2       = 0.6
      x1_end   = 10.0
      y1_end   = 0.2
      x2_end   = 14.0
      y2_end   = 0.6
      min_hits = 10
   }
}

out_hook {
   exists        = yes
   header        = yes
   eof           = no
   tool_change   = yes
   tool_finish   = no
   full_sr_start = no
   full_sr_end   = no
}